Steps for a simple batch Axon in Algoreus
To construct a straightforward batch Axon, execute the following steps:
Launch the Genesis
Opt for Axon - Batch.
Assign a name to the Axon and supplement it with a description. Please note that the name should not contain spaces. For additional details regarding acceptable characters, refer to the Naming Conventions section.
Navigate to the node palette and select the sources required for your axon.
To configure each source, hover over the corresponding source node. A Properties button will emerge. Click on this Properties button to proceed.
After the source properties are configured, click Validate to ascertain that the source is devoid of errors. This validation step is crucial, particularly if any modifications have been made in the Output Schema field.
In case any validation is skipped and errors persist, the error count will be exhibited in the top-right corner of the source node.
To incorporate transformations into the data axon, select transformations from the Transform and Analytics sections.
Establish a connection between the source and the transformation.
Configure the transformation by clicking on the Properties button.
Post configuration, click Validate to ensure that the transformation is error-free.
In the Sink section, select the required Sink for your axon. Subsequently, connect this Sink to the preceding transformation and configure the Sink properties.
Click Save. Upon saving, the axon can be located under Drafts on the List page.
Last updated
Was this helpful?